The Edwards SIGA-ST is a Signature Series service tool kit for fire alarm technicians. Specifically, it packages the SLC diagnostic tools used during commissioning and service on Edwards Signature loop systems.
First, the technician connects the kit to the Signature Data Circuit. Then the included tools support address verification, loop mapping checks, and module-level troubleshooting. As a result, the technician can resolve SLC faults without pulling individual devices.
Product type
- Service tool kit — used during commissioning and troubleshooting only
- Not a permanently installed fire alarm system component
- Intended for trained technicians servicing Edwards Signature Series systems
Compatibility
The SIGA-ST is purpose-built for the Edwards Signature Series Signature Loop Controller. In addition, it works with the SIGA-series intelligent modules and detectors that share that loop. However, it is not compatible with non-Signature Edwards platforms or with other manufacturers’ protocols.
Application
Typical uses include initial loop commissioning, post-installation address verification, periodic maintenance inspections, and fault diagnosis after wiring changes. Furthermore, it supports the documentation workflow required by NFPA 72 inspection-and-test procedures (note: this references the test procedure, not an agency listing of the tool itself).
Ordering and follow-up
If an Edwards-published SIGA-ST data sheet or installation sheet is needed for a specific revision, the Life Safety Consultants team can request one from the manufacturer. Otherwise, this kit is supplied as a complete, factory-assembled service unit.
For more information, contact the Life Safety Consultants team at (888) 557-0558, or email us at: sales@lifesafetycom.com
Additional information
| Weight | 0.5 lbs |
|---|---|
| Dimensions | 5.5 × 6 × 4 in |
| Condition | New |
| Manufacturers | Edwards |
| Part Type | Module |
